Hand Eyelet Cracking Installation flowering setter4mm,8mm,10mm,17mm,20mm,25mmID

Description

Eyelet Cracking tool for eyelets

Internal hole sizes ID 8mm, 10mm, 17mm, 20mm and 25mm

Eyelet sizing most commonly  refers to the internal diameter of the hole, measured in mm. This is the diameter of the hole needed to be cut to fit the eyelet shaft into when setting, not the diameter of the flange.

Use the cracking tool to set eyelets to the medium with no washers.

The cracking tool, flowering tool Splits or cracks the eyelet shaft in neat divisions as it forces the edge of the eyelet to bend out
over the medium,  holding the eyelet securely In place – see photo 

Cracking tools available to suit eyelets with

Diameter  (hole size) 4mm

Diameter  (hole size) 8mm

Diameter  (hole size) 10mm 

Diameter  (hole size) 17mm 

Diameter  (hole size) 20mm
Diameter  (hole size) 25mm